Monterey bay speed dating No reg iphone adult chat
On switches that utilize wire nuts, remove the nuts and untwist the wires.Alternatively, for switches with push-in terminals, insert a small, pointed object such as the end of a paper clip into the terminal-release holes to free the wire ends.
Remove the light bulbs and shades, if the fan is equipped with a light kit.
Separate the short, upper section of beaded chain attached to the speed-control switch from the lower, longer section attached to the fan pull.
The two sections are joined by a somewhat larger connector bead at the top of the chain near the switch.
Each pull of the chain takes the fan up or down a notch in speed before cycling to a stopping point.
Replace either type of switch following the same procedure.
Typically, these wires connect with wire nuts, which you loosen by turning them counterclockwise.